Program Pedalboard for MIDI Output

Our pedalboards are automatically set to MIDI Channel 1. If for some reason the channel has been cleared or you want to change the channel please follow the steps below:

 

After pressing the programming push-button you have about 10-15 seconds to complete each sequence.

You need to press the push-button to start programming each sequence as well.

Set the Pedalboard to send Note On/Off messages. 
 
Press & release programming push-button
Press & release D#2
Press & release “Enter” key (A#2)
 
 
Set the Value of C1
 
Press & release programming push-button
Press & release C#2
Press & release “Enter” key (A#2)
 
 
Set the Channel 
 
Press & release programming push-button
Press & release C#1
Press & release F#2
Press & release C1
Press & release “Enter” key (A#2)
 
 
  • Hits: 11673

© Midiworks 2015